| |
| Visante OCT 3.0 – Third Party Hardware and Software |
| |
The following third party hardware and software has been approved for use with the Visante OCT. Note that all third-party hardware purchased through Carl Zeiss Meditec is pre-configured for use with Carl Zeiss Meditec instruments and include customized installation instructions.
Hardware
Printers1
- HP 6980 A (North America only)
- HP 6980 B (Europe only)
- HP 6988 (USB and network configurations only)
- Brother HL-2700CN (USB and network configurations only)
Network attached storage (NAS) device1
- Netgear ReadyNAS RND4000-100NAS
- D-Link DNS 323
Network switch
- D-Link DGS-22081
- Generic1,2,3
- Interface speed: 10/100/1000 Mb/s
- Interface connectors: RJ-45
- Cable detection: MDI/MDI-X (automatic straight-through or crossover cable detection)
- Supported standards: IEEE 802.3, 802.3u, 802.3ab, and 802.3x
USB hub3
USB (key type) storage device3
Software
Operating System
- Windows XP Service Pack 3
Anti-Virus Software
- Kapersky Anti-Virus 7.0.0.125
- McAfee Virus Scan Enterprise 8.5.0i
Notes:
- The device must not be connected using a shielded cable and it must be placed outside the patient environment. Do not use device with an extension cord or power strip and do not share the same wall outlet with the Visante OCT.
- The device must comply with any local agency requirements. It must have CE approval for use in Europe. It must have UL (or CSA) and FCC approvals for use in North America.
- The device must have CE and/or FCC approvals. The device should be powered from the USB port only.
| |
|